Sainsmart Genmitsu PROVerXL 4030 and 6060 Default GRBL Settings

These are the default GRBL settings for the SainSmart Genmitsu PROVerXL 4030 with notes for the extended 6060 differences.

     To Learn More about the 6060 Extension Kit CLICK HERE>>> 

 

To View and Change your Settings In Easel Select Machine > General Settings > Machine Inspector    ( OR simply Press Ctrl+Shift+D )

Then scroll to the bottom portion labeled "settings" if any need changed, scroll to the top "console" section and enter them one at a time as needed.


$0=10 (Step pulse time)
$1=25 (Step idle delay)    *Best practice is to set this to 255
$2=0 (Step pulse invert)
$3 = 0 (dir port invert)
$4 = 0 (step enable invert, bool)
$5 = 0 (limit pins invert, bool)
$6 = 0 (probe pin invert, bool)
$10 = 3 (status report)
$11 = 0.010 (junction deviation, mm)
$12 = 0.002 (arc tolerance, mm)
$13 = 0 (report inches, bool)
$20 = 0 (soft limits, bool)    *Best Practice is to Set this to 1 and $21 to 0
$21 = 1 (hard limits, bool)
$22 = 1 (homing cycle, bool)
$23 = 0 (homing dir invert)
$24 = 25.000 (homing feed, mm/min)
$25 = 500.000 (homing seek, mm/min)
$26 = 250 (homing debounce, msec)
$27 = 3.000 (homing pull-off, mm)
$30 = 10000 (rpm max)
$31 = 0 (rpm min)
$32 = 0 (Laser, bool)

$100 = 160 (x, step/mm)
$101 = 160 (y, step/mm)
$102 = 160 (z, step/mm)
$110 = 2000 (x max rate, mm/min)
$111 = 2000 (y max rate, mm/min)
$112 = 2000 (z max rate, mm/min)
$120 = 300 (x accel, mm/sec^2)
$121 = 300 (y accel, mm/sec^2)
$122 = 300 (z accel, mm/sec^2)
$130 = 420 (x max travel, mm) *work area will vary for 6060XL =620
$131 = 310 (y max travel, mm) *work area will vary for 6060XL =610
$132 = 110 (z max travel, mm)

 
Great Starter Bits: 
SpeTool WD-2 Router Bits Set

SpeTool WD-2 Router Bits Set

.

Interested In Carving 3D like this?  

Try for free with this link: 90 days of Carveco Maker FREE


Older Post Newer Post


Leave a comment