These are the default GRBL settings for a stock X-Carve.
If you have any of the 2021 upgrades like the 9mm belts or the extended Z then your $3, $100, $101, $102, and $132 will be different reference these changes here: Changing GRBL Settings for the 9mm Belt and Linear Rail Z Upgrades on your X-Carve
To View and Change your Settings In Easel Select Machine > General Settings > Machine Inspector ( OR simply Press Ctrl+Shift+D )
Then scroll to the bottom portion labeled "settings" if any need changed, scroll to the top "console" section and enter them one at a time as needed.
$0=10 (Step pulse time)
$1=255 (Step idle delay)
$2=0 (Step pulse invert)
$3 = 3 (dir port invert mask:00000011) *Values may differ for Z-Axis Upgrade
$4 = 0 (step enable invert, bool)
$5 = 0 (limit pins invert, bool)
$6 = 0 (probe pin invert, bool)
$10 = 115 (status report mask:01110011)
$11 = 0.020 (junction deviation, mm)
$12 = 0.002 (arc tolerance, mm)
$13 = 0 (report inches, bool)
$20 = 1 (soft limits, bool)
$21 = 0 (hard limits, bool)
$22 = 1 (homing cycle, bool)
$23 = 3 (homing dir invert mask:00000011)
$24 = 25.000 (homing feed, mm/min)
$25 = 750.000 (homing seek, mm/min)
$26 = 250 (homing debounce, msec)
$27 = 1.000 (homing pull-off, mm)
$30 = 1. (rpm max)
$31 = 0. (rpm min)
$100 = 40 (x, step/mm) *Values differ for 9mm Belt Upgrade
$101 = 40 (y, step/mm) *Values differ for 9mm Belt Upgrade
$102 = 188.947 (z, step/mm) *Values differ for Z-Axis Upgrade
$110 = 8000.000 (x max rate, mm/min)
$111 = 8000.000 (y max rate, mm/min)
$112 = 500.000 (z max rate, mm/min)
$120 = 500.000 (x accel, mm/sec^2)
$121 = 500.000 (y accel, mm/sec^2)
$122 = 50.000 (z accel, mm/sec^2)
$130 = 790.000 (x max travel, mm) *work area will vary with your X-Carve Size, subtract 210 from the size of your X-Carve in mm (750-210=540) & (500-210=290)
$131 = 790.000 (y max travel, mm) *work area will vary with your X-Carve Size, subtract 210 from the size of your X-Carve in mm (750-210=540) & (500-210=290)
$132 = 100.000 (z max travel, mm) *Values differ for Z-Axis Upgrade
SpeTool WD-2 Router Bits Set
.
Interested In Carving 3D like this?
Try for free with this link: 90 days of Carveco Maker FREE